We are doing our best to make sure Sue Pelland Designs patterns are easy to follow and accurate. However, some mistakes inevitably get through our screening process.

Please check each pattern and, if you have an older version, corrections can be found by clicking on the pattern name below. Please check here if you want the latest corrections or further helpful information about any of our patterns.

We apologize for any inconvenience the errors have caused, and thank you for your understanding.

Promise Ring Quilt

There are a few corrections/additions to the Promise Ring Quilt pattern if you bought it before September 2011.

The finished sizes of the quilts are:
Wall, 28″ x 28″
Lap/crib, 46″ x 54″
Queen, 84″ x 100″

Batting should be cotton batting if you are going to do your decorative stitching through all three layers. That way you can add each appliqué element (steps G, H and I) and stitch as you go. If you use poly batting, the batting will melt as you fuse the shapes down, and you will not get any loft.

Instructions for Crib/Lap size and Queen size quilts (page 8):
Crib/lap size Promise Ring Quilt: Cut one background panel 34″ x 42″. Mark a 4 x 5 grid of 8″ squares on the center panel, leaving 1″ all around.
Queen size Promise Ring Quilt: Cut two background panels, 42″ x 66″.
From Pre-fused fabrics, cut 320 2 1/2″ leaves with the Petite Leaves Galore template for leaves (green in photo).
From Pre-fused fabrics, cut 640 2 1/2″ leaves with the Petite Leaves Galore template for flower petals (red/orange in photo).

Mark grid lines on two background panels in 8″ squares, centering grid lines on fabric to leave 1″ border around all four sides. Mark one 66″ edge of each panel with the word “seam” on outside of the grid. Do not place appliqué over this seam line.

Flowers Galore Place Mats

The following are changes to the Flowers Galore Place Mats patterns printed before September 2011.

The backing fabric and batting, one yard cut in four 14″ x 22″ rectangles.

If you bought the Flowers Galore Place Mats pattern between May 16th and June 16th, 2011, you may be missing a one page insert, not stapled into the booklet. This insert illustrates how to cut the petals for the sunflower, poinsettia and daisy flowers. If your pattern does not contain this supplement, you can go to my online shop and print the free PDF file for this supplement. You will not be charged for this PDF download.

Melissa’s Quilt

On the back cover, the correct yardage for backing the crib size quilt is 1 1/2 yards, and for the  double size quilt is 4 3/4 yards.

Cut the borders for the crib size quilt 7 1/2″ x 27″ and 7 1/2″ x 38″.  Table one is incorrect, however, the fabric cutting diagram on page two is correct.

For the miniature quilt, cut borders 3 1/2″ x 10 1/2″ and 3 1/2″ x 16 1/2″.  Finished quilt size is 14″ x 16 1/2″.

Hope’s Diamond

Hope’s Diamond is a beautiful quilt that uses the Grande Leaves Galore template to trim the edges from a 60 degree diamond, making curved diamonds.  A bonus quilt can be made from the trimmings of your diamonds.  Watch for the free download that will soon be available on the patterns page.

When cutting the 60 degree diamonds for Hope’s Diamond, make sure you cut 5 1/4″ strips, then cut the 60 degree angle from the end of your strip.  From the 60 degree angle, cross cut the strips using the 5 1/4″ mark on your ruler.  The instructions point out that the final size of your diamonds measures 6″ on each side, but this is a function of the angles.  You never use the 6″ marking on your ruler to cut the diamonds.

Some fat quarters may not be 18″ x 22″.  If your fat quarters are short, you may not get 3 full diamonds from each of the strips.  In that case, you will need to fuse the extra strip of fabric that you removed from the fat quarter to cut more diamonds.

He Loves Me

If you purchased your pattern prior to 12/25/14, please check the back of your pattern, as well as pages 5 and 8.  You will need to use a 12″ square to cut out the two background hearts as shown in photo 3 on Page 8.

Inner Border:  Inner border needs to be 37 1/2″ long, not 37″ long.  Cut borders the full width of fabric, then cut down to size when adding the borders.

Outer Border:  Outer borders need to be 44 1/2″  long.  Fabric is generally not 45″ wide, so you can add cornerstones to two of the borders to make them long enough.  Sew two borders (cut at 4″ x 37 1/2″) to right and left side of quilt.  Cut four cornerstones, 4″ square from the left over sashing yardage.  Add cornerstones to two borders cut 4″ x 37 1/2″.  Sew these two borders onto top and bottom of the quilt matching seams at the cornerstones.

Note:   Before you cut these borders, double check the measurement of the quilt after adding your inner border.  Make sure it is 37 1/2″ or adjust your border measurement to fit your quilt as it is sewn.

Hearts & More Rotary Cut Appliqué

These corrections are available as a PDF file if you would like to print them out and insert them into your book:

On page 38, Photo 3 is incorrect, photo 4 is correct. Please refer to these two new photos that make the markings easier to see. 

Photo 3:

 Photo 4:


On page 55, The labels on the clam shell photos are re-versed. The straight-edge bottom clam shell is pictured in Pho-to 1. The pointy bottom clam shell is pictured in Photo 2. 

On Page 55, Daisy Flowers Petals: Using Hearts and More Template A small end from zero degrees to "O" to make eight straight-edge petals each of five different fabrics. (Photo 5 and 5A) 

PROJECT 4: Mediterranean Blues, Page 68 

On Page 68, Step D: Assemble Blocks - the instructions for Block 2 should read (Make 32). 

PROJECT 7: Drunkard’s Path, Page 77, Please correct the following diagrams: 

Rotary Cut Appliqué with Leaves Galore Templates-Project 2: Magic Carpet Ride

On page 62

Diagram 2 and the instructions for cutting lemon-shaped leaves have an incorrect measurement.  Replace the 22" notation on the diagram with 25". The written instructions should read:  The "a" marks on the template will line up with the 1", 9" 17", 25" and 33" lines.  


Conversation Hearts

Front Cover– Finished size is 60½ x 70½

Section B: Fabric cutting

Correct italic words:  From A:  Cut three 2½” x WOF strips, then cut in half to make six 2½ x22” strips.

Correct Italic words: From B:  Cut two 2½” x 44” strips. Cut in half to make four 2½” x 22” strips

From Background Fabric:

Correct italic words in line one: Cut eight 2½” x WOF strips. Cut in half to make sixteen strips used in Units 1,2 ,and 3.

Add this new instruction: Cut eight 2½”x WOF strips used in Unit 5.

Add italic words in line two:  Cut three 6½”x WOF . Cut in half to make six strips used in Units 6 and 7.

Follow the final 2 instructions as written in the pattern. 

Section E: Fuse and stitch hearts

After decorative stitching is complete, trim all four sides to square up heart blocks to 7½” square.  Click here to see pictures of this step. 

Section G: Framed Nine Patch blocks for border

Lettering for strips is incorrect.

Unit 2: change fabric A to E

Unit 3: change fabric E to B

Unit 5:  From the eight 2½”x WOF background strips cut in Section B: Cut into forty-four   6½” segments. Sew to opposite sides of Unit 4.  Press seams outward. 

Unit 6: change fabric B to E

Unit 7: change fabric E to A

Section I: Piece quilt top

The correct measurement for squaring up the quilt top after adding inside (colored) border pieces is 40½” x 50½”.


Star Struck

The Star Struck yardage for the Queen/Full quilt has been revised in November 2017.  If you purchased your pattern before November, 2017, please check to make sure your yardage matches this document. 

We then added a background cutting diagram to make sure you cut it correctly and you don't run out of fabric!  

Queen/Full Size Fabric 1: Background 4 1/8 yards

Lap/Crib/Wall Size Fabric 1: Background 1 7/8 yards